20M Beryllium Copper Tape steppir

Berilio 20M Copper Tape for Motor Steppir

Cable de interfaz YAESU S13

Cane end cap SteppIR (Foam plug assembly)

[Foam Plug Assembly] Rubber stopper with internal felt to put on the end of the antenna reeds steppir or for other uses.Price for 1 Unit.

Chip Mando FluidMotion 4804 MK3 Vertical Antena

Chip para mando FluitMotion de SteppIR Modelo: 4804  (MK3) Vertical Antena Cantidad: 1 unidad Sólo CHIP no incluye pinzas ni utensilios para el cambio.

Chip Mando FluidMotion 4804B MK2 BigIR Vertical Antena

Chip para mando FluitMotion de SteppIR Modelo: 4804B  (MK2) BigIR Vertical Antena Cantidad: 1 unidad Sólo CHIP no incluye pinzas ni utensilios para el cambio.

Chip Mando FluidMotion 4904 MK3 Vertical Antena

Chip para mando FluitMotion de SteppIR Modelo: 4904  (MK3) Vertical Antena Cantidad: 1 unidad Sólo CHIP no incluye pinzas ni utensilios para el cambio.

Chip Mando FluidMotion 4904B MK2 Vertical Antena

Chip para mando FluitMotion de SteppIR Modelo: 4904B  (MK2) Vertical Antena Cantidad: 1 unidad Sólo CHIP no incluye pinzas ni utensilios para el cambio.

Chip Mando FluidMotion 6704 Yagi Beam 4 elem.

Chip para mando FluitMotion de SteppIR Modelo: 6704  (Yagi 4 elements) 6 to 20 mts. Cantidad: 1 unidad Sólo CHIP no incluye pinzas ni utensilios para el cambio.

Cinta de Vinilo 3M™ Scotch® Super 88 Negra 38mm

High quality insulating tape for weathering, water resistant, cold (low temperatures), heat (high temperatures). Color: Black

Curve Trombone steppir

Trombon curve for Yagi steppir antennas with 30/40 Mts.1 unit

DB25 connector

Fluid Motion, SDA1000 or SDA2000 Optimized controller steppir connector

Element Bracket Steppir 1,8"

Bracket, stainless steel joint for the joint of the Trombone that does not have the motor. For Boom (Tube) 45mm 1.8"1 unit (U-plate) Does not include hardware or hardware.

End stop tape steppir

End-of-career stop of the internal steppir.

High Wind Motor Kit/Antenna Rods steppir

High wind motor kit/reeds for Yagi antennas steppir The KIT includes: Machined sheet stainless steel 4mm thick. 4 Rubber rubbers (3 fat and 1 thin). 4 PolyproPilene flanges of 50mm. 4 Separators. 8 M-6x90mm long screws (with washer and nuts) Stainless steel. for the 4 flanges. 10 M-5x30mm screws (with washer and nuts) to anchor the motor to the sheet...

Interface cable "Y"

02114 Y connector cable for SDA 100 Transceiver InterfaceThe 'Y' cable is used to connect a computer registration program, a transceiver and the SDA 100 to a unique communication port; The Y cable is not required with Icom Radios; Must be used with the transceiver interface module and radio-specific interface cable (each sold separately)

Motor connector Vertical-Dipole antenna STEPPIR

Connector for the Vertical-Dipole Antenna steppir

Motor connector Vertical-Dipole antenna STEPPIR

Connector for the cable to the Vertical Antenna-Dipole motor steppir

Motor Gasket steppir (Old Style)

Motor seal steppir. It ingies and prevents moisture inside the engine. EHU Gasket

Motor output cone steppir

Motor output cone.

Motor Replacement Axis

Replacement Axle (Gear) Motor steppir. Engine axle with 2 sprockets.

Passive Element 6M 2the steppir

KIT 50mhz 2E

Passive motor brush [steppir]

Passive Motor brush. Brush Assembly - Passive

Plate with motor shaft 6-20m steppir

Plate with motor shaft 6-20M.Mounting plate.

Plate with motor shaft 6-40m steppir

Plate with motor shaft 6-40M.Mounting plate.