Antennas steppir
New products
Accessories Steppir
There are 29 products.
Advanced Lightning Protection Module (ALP)
Advanced Lightning Protection Module (ALP) for SDA 100 electronic steppir. Each controller chip has a relay in front of it that protects against lightning, near-ray incidents, static electricity and short circuits. The module will only work if the antenna is not in the process of being adjusted when the discharge occurs.
High Wind Motor Kit/Antenna Rods steppir
High wind motor kit/reeds for Yagi antennas steppirThe KIT includes: Machined sheet stainless steel 4mm thick. 4 Rubber rubbers (3 fat and 1 thin). 4 PolyproPilene flanges of 50mm. 4 Separators. 8 M-6x90mm long screws (with washer and nuts) Stainless steel. for the 4 flanges. 10 M-5x30mm screws (with washer and nuts) to anchor the motor to the sheet...
Interface cable "Y"
02114 Y connector cable for SDA 100 Transceiver InterfaceThe 'Y' cable is used to connect a computer registration program, a transceiver and the SDA 100 to a unique communication port; The Y cable is not required with Icom Radios; Must be used with the transceiver interface module and radio-specific interface cable (each sold separately)
MERCO Black Insulating Tape
High quality insulating tape for weathering, water resistant, cold (low temperatures), heat (high temperatures).Color: Black
Passive Elements 6M 4the steppir
KIT 50mhz steppir 4 Elements (Two Passive Aluminum Elements).
Passive Elements 6M DB-42 4the steppir
KIT 50mhz steppir for 5 Elements (Two three aluminum liabilities for Model DB-42).
Shielded 8-wire Dataflex cable (Pack 25 Meters)
Shielded 8-wire control cable.Pack 25 meters
